Splitcake Palette Glow - Touch of Neon

Palette with 6 Splitcakes of 6 g each.

Diamond FX Facepaint is a water-based color and can be applied directly to the skin. To "activate" it, a small amount of water is required. The less water you use, the better the result.
You can use sponges and/or brushes to apply:

- Sponges

You can cut the sponge in half and use two colors on each half. With the back (the protruding part of the sponge), you can blend the colors. Wet only the tip and squeeze out most of the water so that it is slightly damp, rub it on the color until it absorbs some. Now you can apply the color to the face by rotating the sponge on the skin. Never leave the sponge on the color pot.

- Brushes

Wet the brush and dry excess water with a paper towel, pass it over the color making it enter between the bristles. Now place the brush on the skin and create your makeup. After using it, never leave the brush in the color pot or in the water.

Safety and Hygiene

Always ensure to work in the cleanest possible conditions. Use a clean sponge and/or brush for each person. To ensure that your material is clean and sanitized, use appropriate cleaning products.
Make sure that the color inside the pot is dry before closing it with the lid. Do not leave traces of water inside because this could cause the formation of bacteria.
If irritation occurs on the skin during use, stop using the product immediately.
Do not leave the color around the eyes and mouth for too long as these are sensitive areas of the skin.
Do not mix Diamond FX Facepaint with other brands to avoid damaging the products.